Nominal diameter | 4″ / 102 mm |
Resonance | 70 Hz |
Q factor | 0.36 |
Sensitivity | 88.8 dB |
Linear excursion | ± 2.4 mm |
Program Power | 50 W |
Driver
Port
Combined
Frequency response
Hz
Impedance
Ω
Impedance Phase
°
Excursion
mm
Velocity
m/s
SPL
dB
Acoustical Phase
°
Group Delay
ms
Transient response
ms
- Sensitivity (1W, 1m, infinite baffle) SPL1W 88.8dB
- Frequency response 70 - 20000Hz
Thiele & Small parameters
- Resonance frequency (free air) fS 70Hz
- Mechanical quality factor QMS 2.26
- Electrical quality factor QES 0.43
- Total quality factor QTS 0.36
Large signal parameters
- Maximum linear excursion xmax 2.4mm
- Air volume displaced at xmax VD 14cm³
- Power handling P 25W
- Program power Pmax 50W
Voice Coil
- Nominal impedance Z 4Ω
- DC resistance RE 3.4Ω
- Inductance (1kHz) LE 0.009mH
- VC Diameter 25.4mm
Magnet
- Force factor Bl 3.54N/A
- Motor constant Bl/√RE 1.92N/√W
- Air gap height HAG 10mm
- Material Ferrite
Diaphragm
- Effective diameter 85mm
- Effective area SD 57cm²
- Moving mass MMS 3.99g
- Moving mass (without air load) MMD 3.7g
- Material Paper
Suspensions
- Stiffness KMS 0.623N/mm
- Compliance CMS 1605µm/N
- Equivalent volume to the compliance VAS 7.4L
- Mechanical resistance RMS 0.78N·s/m
- Surround material Rubber
Dimensions
- Nominal diameter 4″
- 102mm
- Volume occupied by the driver (estimated) 0.74L
- Net weight 1.82kg
Similar speaker drivers to Tang Band W4-1320SMF
Tang Band W4-21428 Ω |
---|
4″ Full-range |
fS | 60 Hz |
SD | 57 cm² |
60 - 20000 Hz |
QTS | 0.33 |
xmax | 2.4 mm |
SPL1W | 88.5 dB |
Bl/√RE | 2.16 |
Pmax | 50 W |
Tang Band W4-1052SDF4 Ω |
---|
4″ Full-range |
fS | 70 Hz |
SD | 57 cm² |
70 - 17000 Hz |
QTS | 0.42 |
xmax | 2.6 mm |
SPL1W | 87.7 dB |
Bl/√RE | 2.1 |
Pmax | 40 W |
Tang Band W4-1749S8 Ω |
---|
4″ Coaxial |
fS | 60 Hz |
SD | 57 cm² |
60 - 20000 Hz |
QTS | 0.34 |
xmax | 0.9 mm |
SPL1W | 87.9 dB |
Bl/√RE | 2.22 |
Pmax | 50 W |